PowaWash

ONLY 1 LEFT – 5LTR

PowaWash is a powerful, industrial strength, natural cleaner/degreaser it is biodegradable, non toxic, non flammable and does not alter the pH of waste water.

Surfaces dry fast after wash off.

$85.79

1 in stock

Enquire

FOR ALL CUSTOMISATION PLEASE CONTACT US ON 08 9334 1010

MATERIALS & CONSTRUCTION

Solvent extracted from plant materials blended with citrus and surfactant to enable emulsification with water

PHYSICAL PROPERTIES

  • Appearance: Clear yellow liquid
  • Boiling point: > 150ºC
  • Flash Point: 88ºC
  • Specific Gravity: 0.86 @ 25ºC
  • Solubility in Water: Emulsifies
  • Viscosity: 10cST @ 20ºC

APPLICATIONS

  • A powerful, industrial strength, natural cleaner/degreaser concentrate
  • Parts washing solvent
  • Heavy machinery & heavy plant cleaner/degreaser
  • Removal of bitumen based greases (crater grease, open gear grease, blackjack)
  • Removal of oil, grease, tar, shipping waxes, anti-seize
  • Asphalt & bitumen remover & clean up
  • Formulated to remove Lanotec lanolin based products

DIRECTIONS FOR USE

Height Safety Equipment including Harnesses, Lanyards, Ropes and Slings

  • For washing/bathing – a dilution of 5 parts water to 1 part PowaWash, clean any residuals with fresh water.
  • Any grease or stains, spray with 100% PowaWash and wash off the residual with fresh water.
  • Hang out to dry at room temperature, out of direct sunlight and do not expose to direct heat.

Degreasing

  • For light oils & grease – A dilution of 6:1 spray affected area and let sit for 5 mins. High pressure wash off.
  • For blackjack and crater grease apply neat, agitate with stiff brush, then high pressure clean, repeat where necessary.
  • For heavy grease, high pressure clean excess off equipment, apply PowaWash neat, let sit for 1 minute, high pressure wash off.

Use in Parts Washer

  • When using PowaWash as a parts cleaning solvent, always use neat. When fluid stops cleaning, can be disposed of into oil/water separator.

Workshop Floors

  • For cleaning workshop floors, spray onto affected area, lightly broom, and high pressure wash off.
  • Can be added to floor scrubbing machines at various dilution rates.

Metal Fabrication & Paint Preparation

  • For removal of light oils and fingerprints, spray onto affected area diluted at 1:6 parts water.
  • Wipe with rag to remove or high pressure clean for large equipment.
  • Leave until dry. Surface will be free of oil residue.